PRESSURE BRUSH

Painting with a pressure brush becomes really efficient.

With a pressure brush, the paint comes from the pressure tank through a hose to the brush using pressure.

The flow of paint is adjusted with a tap.

With a pressure brush, you can paint about 25-30m2 of wall with one can.

The pressure brush works with all paints.

When using thinner paints, it is enough to keep only a little pressure in the can, then it is easier to regulate the paint.

When painting with thicker paints, the pressure can be pumped up to full. When the pressure relief valve rises slightly, there is enough pressure.

USER MANUAL 
 INSTRUCTIONS FOR USE

-MAKE SURE THAT THE CONNECTIONS ARE NOT LOOSE!

TEST WITH WATER BEFORE ADDING PAINT!

-FILL WITH PAINT TO APPROX. 5L MARK

-PUMP UP THE PRESSURE INTO THE TANK UNTIL THE OVERPRESSURE VALVE RISES A LITTLE.

-FOLLOW THE AMOUNT OF PAINT IN THE TANK AND ADD PAINT BEFORE THE TANK IS EMPTY, SO THAT NO AIR GETS INTO THE HOSE AND THE BRUSH DOES NOT SPRAY PAINT.

----------------------------------------------------------------------------------

!!!!!!NOTE!!!!!

NEVER OPEN THE TANK FILLING HOLE WHEN THE TANK IS PRESSURED!! RELEASE THE PRESSURE FROM THE SAFETY VALVE FIRST.

!!!!!NOTE!!!!!

----------------------------------------------------------------------------------

-WHEN PAINTING WITH A BRUSH ONLY, THE CONTROLLER IS IN ONE HAND AND THE BRUSH IN THE OTHER.

WITH A THUMB-ADJUSTED TAP, THE PAINT IS ADJUSTED "IN CYCLES" ENOUGH. NOT BY OPENING THE TAP PROPERLY, BUT BY SLIPPING APPROPRIATE DOSES OF PAINT WITH YOUR THUMB.

-WHEN PAINTING WITH AN EXTENSION ARM, THE CONTROLLER IS AT THE END OF THE EXTENSION ARM. THE PAINT IS DISPENSED IN CYCLES IN THE SAME WAY AS WHEN PAINTING WITH A BRUSH.

-WHEN YOU FINISH PAINTING, PUT A BAG ON THE BRUSH AND LET THE BRUSH WET. RELEASE THE PRESSURE FROM THE PRESSURE PUMP BY LIFTING THE OVERPRESSURE VALVE.

-THE TANK AND HOSES DO NOT NEED TO BE WASHED FOR A LONG TIME, UNLESS THE PAINT COLOR CHANGES.

-WASHING IS EASY WITH A WASHER. POUR THE PAINT FROM THE TANK INTO A CONTAINER. ADD A LITTLE WATER AND SHAKE MOST OF THE PAINT FROM THE EDGES AND POUR IT INTO A PAINT BUCKET.

-ADD 2L OF WATER, PUT THE WASHER AND THE WASHER CAP INTO PLACE, ROTATE THE WASHER WITH A DRILL AND MOVE UP AND DOWN FOR ABOUT 1 MIN. POUR THE WASHING WATER INTO A BUCKET, AND DRAIN THE TANK AND THE WASHING IS COMPLETE.

THE HOSES ARE EASY TO WASH BY CONNECTING THEM DIRECTLY TO A WATER PIPING AND LET THE WATER RUN THROUGH.